Communications Systems Design (CSD)5 ECTS
(englische Bezeichnung: Communications Systems Design)
(Prüfungsordnungsmodul: Technische Wahlmodule)

Lehrveranstaltungen:

• • Communications Systems Design
    (Vorlesung, 2 SWS, Georg Fischer et al., Fr, 10:15 - 11:45, 0.151-115)

Empfohlene Voraussetzungen:

Bachelor Courses on Circuit and System design Bachelor Courses on Digital Modulation and MIMO Bachelor Courses on RF circuit Design

Inhalt:

• Introduction

• Analogue-Digital Balance

• Software Defined Radio

• ADC/DAC Converter Performance Metrics and their evolution over time

• Signal Distortion mechanisms and metrics (IP3, EVM, ACPR, Spectral mask, wideband noise, reverse intermod)

• Impairment modelling

• System Complexity Analysis for Mixed Signal Systems

• Transceiver architectures, design and analysis

• Chained Noise figures and IP3 figures

• Dynamic Range in RX and TX, Automatic Gain Control in RX and power control in TX

• Synchronous versus asynchronous Architectures (RF DAC, PLM)

• Challenges by Duplex operation, FDD, TDD, same frequency, TX-RX

isolation, transmitter leakage cancelation

• Simulation techniques (HB, Transient, Circuit Envelope)

• Power Amplifier Systems, Amplifier architectures, Vector quantised PA, Class-S, DSM, PWM

• Amplifier linearization, digital predistortion

• MIMO Architectures

• Implementation of Active Antenna Arrays, calibration

• Spectrum Engineering

• Physical Layer definition in light of implementation challenges
  

The exercise will be conducted based on PC and USRP Software Defined Radios. National Instruments Labview Comsuite Toolbox will be used for designing and studying Communication Systems.

Lernziele und Kompetenzen:

Students

• can compare key performance indicators of alternative transceiver architectures

• can construct the line up with TX and RX

• can formulate requirements for transceivers

• can gauge isolation between TX and RX

• can choose a power amplifier class based on requirements

• can rate physical layer properties

• can assess complexity in analogue and digital domain

• can plan a simulation strategy for analysing transceivers -can categorise transceiver architectures for single or multiple antennas

• Can develop a predistorion system for power amplifiers

Literatur:

Ralf Rudersdorfer, Radio Receiver Technology: Principles, Architectures and Applications, Wiley, 2014

Frank Ellinger, Radio Frequency Integrated Circuits and Technologies, Springer, 2008

Abbas Mohammadi und Fadhel M. Ghannouchi, RF Transceiver Design for MIMO Wireless Communications, Springer, 2012

Verwendbarkeit des Moduls / Einpassung in den Musterstudienplan:

1. Communications and Multimedia Engineering (Master of Science)
   (Po-Vers. 2011 | TechFak | Communications and Multimedia Engineering (Master of Science) | Masterprüfung | Wahlmodule | Technische Wahlmodule)

Studien-/Prüfungsleistungen:

Commmunications Systems Design (Prüfungsnummer: 700506)

(englischer Titel: Commmunications Systems Design)

Prüfungsleistung, mündliche Prüfung, Dauer (in Minuten): 30, benotet

Anteil an der Berechnung der Modulnote: 100.0 %

Prüfungssprache: Englisch

Erstablegung: WS 2018/2019, 1. Wdh.: SS 2019

1. Prüfer:

Georg Fischer,

2. Prüfer:

Robert Weigel